Hazard Warning Switch Test
1. Remove the dashboard lower cover (see page
23-220).
2. Disconnect the 20-P connector from the floor wire
harness.
3. Check for continuity between the terminals, in each
switch position, according to the table.
HAZARD WARNING SWITCH
View from wire side Terminal N is
not used.
1. Remove the dashboard lower cover (see page
23-220).
2. Disconnect the 20-P connector from the floor wire
harness.
3. Check for continuity between the terminals, in each
switch position, according to the table.
HAZARD WARNING SWITCH
View from wire side Terminal N is
not used.