Cancel Unit Input Test
1. Remove the steering column covers. Disconnect the
10-P connector from the turn signal cancel unit.
2. Inspect the connector terminals to be sure they are
all making good contact.
• If the terminals are bent, loose or corroded, repair
them as necessary, and recheck the system.
• If the terminals look OK, make the following input
tests at the connector.
— If any test indicates a problem, find and correct
the cause, then recheck the system.
— If all the input tests prove OK, the control unit
must be faulty; replace it.
10-P CONNECTOR
TURN SIGNAL
CANCEL UNIT
No. Terminal Test condition Test: Desired result Possible cause if result is not obtained
1. Remove the steering column covers. Disconnect the
10-P connector from the turn signal cancel unit.
2. Inspect the connector terminals to be sure they are
all making good contact.
• If the terminals are bent, loose or corroded, repair
them as necessary, and recheck the system.
• If the terminals look OK, make the following input
tests at the connector.
— If any test indicates a problem, find and correct
the cause, then recheck the system.
— If all the input tests prove OK, the control unit
must be faulty; replace it.
10-P CONNECTOR
TURN SIGNAL
CANCEL UNIT
No. Terminal Test condition Test: Desired result Possible cause if result is not obtained