nsxb22067a.pdf

Blower Unit
Replacement
1. Remove the spare tire (refer to Owner’s manual).
2. Remove the spare tire holder.
CORROSION RESISTANT BOLT
6 x 1.0 mm
10 N-m (1.0 kg-m, 7 Ib-ft)
SPARE TIRE
HOLDER
3. Disconnect the cables from the battery, loosen the
hold-down bracket nuts, and remove the hold-
down bracket. Then, remove the battery.
BATTERY
HOLD-DOWN
BRACKET
4. Remove the under-hood relay box A and the water
drain duct. Disconnect the connectors from the
blower motor, power transistor and recirculation
control motor.
CORROSION RESISTANT BOLT
6 x 1.0 mm
10 N-m (1.0 kg-m, 7 Ib-ft)
WATER
DRAIN
DUCT
BLOWER MOTOR,
POWER TRANSISTOR,
and RECIRCULATION CONTROL
MOTOR CONNECTORS 6 x 1.0 mm
10 N-m (1.0 kg-m, 7 Ib-ft)
5. Remove the mounting bolts, then remove the blower
unit.
CORROSION RESISTANT BOLT
BLOWER
UNIT
6 x 1.0 mm
10 N-m (1.0 kg-m, 7 Ib-ft)
6. Install the blower unit in the reverse order of
removal, then make sure it runs and doesn’t leak
any air.
UNDER-HOOD
RELAY
BOX A