nsxb20060a.pdf

Rear Bumper
Replacement
1. Fold the trunk floor trim panel forward, and remove the bumper mounting nuts.
2. Remove the bumper mounting nuts on each side from under the trunk floor.
3. Lower the inner fender.
4. Remove the skirt mounting bolts and under covers from inside the rear fender on each side.
5. Remove the bumper mounting nuts on each side.
6. Remove the rear bumper by sliding it to the rear.
NOTE:
• Disconnect the license light connector.
• An assistant is helpful when removing the rear bumper.
• Take care not to scratch the rear bumper.
BUMPER MOUNTING NUTS
6 x 1.0 mm
10 N-m (1.0 kg-m,
7.2 Ib-ft)
BUMPER MOUNTING NUT
8 x 1.25 mm
22 N-m (2.2 kg-m,
16 Ib-ft)
TRUNK FLOOR TRIM PANEL
(see page 20-66)
BUMPER SKIRT MOUNTING
BOLT
6 x 1.0 mm
10 N-m (1.0 kg-m, 7.2 Ib-ft)
INNER FENDER
REAR BUMPER UNDER COVER
LICENSE LIGHT
CONNECTOR
BUMPER MOUNTING
NUTS
8 x 1.25 mm
22 N-m (2.2 kg-m, 16 Ib-ft)
7. Installation is the reverse of the removal procedure. CORROSION RESISTANT BOLT/NUT