nsxb06013a.pdf

Timing Belt
Illustrated Index
NOTE:
Refer to page 6-18 (’91-’93) or (’94-’96) for positioning crankshaft and pulley before installing the belt.
if it is to be reused, mark the direction of rotation on the belt before removing.
Do not use the middle cover and lower cover for storing removed items.
Clean the middle cover and lower cover before installing.
Replace the camshaft seals and crankshaft seals if there is oil leakage.
Refer to page 6-12 (’91-’93) or (’94-’96) before installing timing belt.
CYLINDER HEAD COVER
Refer to page 6-47 (’91-’93) or (’94-’96)
when installing
RUBBER SEALS
Replace when damaged
or deteriorated.
6 x 1.0 mm
12N·m (1.2 kg-m,
9 Ib-ft)
6 x 1.0 mm
12N·m (1.2 kg-m.
9 Ib-ft)
MIDDLE
COVER
RUBBER SEALS
Replace when damaged
or deteriorated.
LOWER COVER
6 x 1.0 mm
12 N·m (1.2 kg-m,
9 Ib-ft)
CRANKSHAFT
PULLEY
Replacement,
page 6-12 (’91-’93) or (’94-’96)
PULLEY BOLT
16x 1.5 mm
250 N·m (25.0 kg-m.
181 Ib-ft)
Replacement,
page 6-12 (’91-’93) or (’94-’96)
Do not use an impact
wrench when installing.
HEAD COVER GASKET
Replace when leaking,
damaged or deteriorated.
Apply liquid gasket at
the eight corners of the
ecesses
CAP NUT
6 x 1.0 mm
10N m (1.0 kg-m,
7 Ib-ft)
WASHERS
Replace when damaged
or deteriorated.
RUBBER SEALS
Replace when damaged
or deteriorated.
ADJUSTING BOLT
10 x 1.25 mm
43N.m (4.3 kg-m.31 Ib-ft)
For adjustment only,
do not remove.
COLLARS
TIMING BELT
Inspection, page 6-14 (’91-’93) or (’94-’96)
Adjustment, page 6-14 (’91-’93) or (’94-’96)
Install with concave
surface facing out.
6 x 1.0 mm
12N·m (1.2 kg-m, 9 Ib-ft)