Categories
Heating, Ventilation and Air Conditioning

nsxb22060a.pdf

Vent Door Control Motor Replacement 1. Remove the three screws and vent door control motor. VENT DOOR CONTROL MOTOR 2. Install the vent door control motor in the reverse order of removal. Then apply battery voltage, and watch the door move. • Make sure that the vent door moves smoothly without binding. • Make sure […]

Categories
Heating, Ventilation and Air Conditioning

nsxb22067a.pdf

Blower Unit Replacement 1. Remove the spare tire (refer to Owner’s manual). 2. Remove the spare tire holder. CORROSION RESISTANT BOLT 6 x 1.0 mm 10 N-m (1.0 kg-m, 7 Ib-ft) SPARE TIRE HOLDER 3. Disconnect the cables from the battery, loosen the hold-down bracket nuts, and remove the hold- down bracket. Then, remove the […]

Categories
Heating, Ventilation and Air Conditioning

nsxb22009a.pdf

SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section 24 before performing repairs or service. POWER TRANSISTOR BLOWER MOTOR RECIRCULATION CONTROL MOTOR CONDENSER FAN MOTOR UNDER-HOOD RELAY BOX A (CONDENSER FAN RELAY, COMPRESSOR CLUTCH RELAY, BLOWER MOTOR HIGH RELAY, BLOWER MOTOR RELAY) UNDER-HOOD FUSE/RELAY BOX […]

Categories
Heating, Ventilation and Air Conditioning

nsxb22015a.pdf

Climate Control Unit Input/Output Signals CLIMATE CONTROL UNIT Main Menu Table of Contents — Climate Control Unit Input/Output Signals CLIMATE CONTROL UNIT View from wire side _I 30P: No. Wire Color Signal No. Wire Color Signal 1 GRN/BLU Air Mix control Motor [COOL €9) Output 16 RED/BLU Mode DEF Output 2 RED/VEL Mode VENT Input […]

Categories
Heating, Ventilation and Air Conditioning

nsxb22055a.pdf

Adjustment The calibration switch can raise or lower the set temper- ature by ± 3°F (1.5°C) in relation to the digitally- displayed temperature. Attachments nsxb22055a (32 kB)

Categories
Heating, Ventilation and Air Conditioning

nsxb22085a.pdf

Clutch Inspection • Check the plated parts of the pressure plate for color changes, peeling or other damage. If there is dam- age, replace the clutch set. ,• Check the pulley bearing play and drag by rotating the pulley by hand. Replace the clutch set with a new one if it is noisy or has […]

Categories
Heating, Ventilation and Air Conditioning

nsxb22078a.pdf

Condenser Description Dual condensers are mounted behind the right and left side of the front bumper as shown. The cooling efficiency of parallel- dual condensers is as good as or better than a single condenser mounted in front of radiator. LEFT CONDENSER New parts (R-134a) RECEIVER/DRYER New parts (R-134a) RIGHT CONDENSOR New parts (R-134a) Attachments […]

Categories
Heating, Ventilation and Air Conditioning

nsxb22054a.pdf

Climate Control Unit Replacement SRS components are located in this area. Review the SRS component locations, precautions, and procedures in the SRS section 24 before performing repairs or service. 1. Remove the clock (see section 23). 2. Remove the two screws behind the clock, then remove the center air vent (see section 20). 3. Take […]

Categories
Heating, Ventilation and Air Conditioning

nsxb22056a.pdf

Air Mix Control Motor Replacement 1. Disconnect the heater valve cable from the air mix control motor. HEATER VALVE CABLE AIR MIX CONTROL MOTOR 2. Remove the three screws and the air mix control motor. AIR MIX CONTROL MOTOR 3. Install the air mix centrol motor in the reverse order of removal, then apply battery […]

Categories
Heating, Ventilation and Air Conditioning

nsxb22003a.pdf

(’93-’96), 86 (’91-’92 Models) MODE CONTROL MOTOR Replacement, page 22-57 (’93-’96), 69 (’91-’92 Models) Test, page 22-58 (’93-’96), 91 (’91-’92 Models) “DEF” DOOR Adjustment, page 22-77 (’92-’96), 72 (’91Models) “HEAT” DOOR Adjustment, page 22-77 (’92-’96), 72 (’91Models) RECIRCULATION CONTROL MOTOR Replacement, page 22-59 (’93-’96), 64 (’91-’92) Test, page 22-59 (’93-’96), 64 (’91-’92 Models)BLOWER UNIT Replacement, […]