Gauge Assembly
Removal
SRS components are located in this area. Review the SRS
component locations, precautions, and procedures in the
SRS section 24 before performing repairs or service.
1. Remove the dashboard lower cover, and disconnect
the floor wire harness connectors.
2. Remove the two screws, then remove the dashboard
lower pad from the dashboard.
DASHBOARD
LOWER
COVER
DASHBOARD
LOWER PAD
3. Remove the three screws, then remove the tilt cover
from the steering column.
TILT COVER
4. Disconnect the connectors from the instrument
panel switches.
5. Remove the six screws, then remove the instrument
panel trim from the dashboard.
INSTRUMENT PANEL TRIM
Removal
SRS components are located in this area. Review the SRS
component locations, precautions, and procedures in the
SRS section 24 before performing repairs or service.
1. Remove the dashboard lower cover, and disconnect
the floor wire harness connectors.
2. Remove the two screws, then remove the dashboard
lower pad from the dashboard.
DASHBOARD
LOWER
COVER
DASHBOARD
LOWER PAD
3. Remove the three screws, then remove the tilt cover
from the steering column.
TILT COVER
4. Disconnect the connectors from the instrument
panel switches.
5. Remove the six screws, then remove the instrument
panel trim from the dashboard.
INSTRUMENT PANEL TRIM
6. Remove the eight screws, then remove the steering
column covers.
UPPER COVER
LOWER COVER
7. Disconnect the 30-P connectors from both sides of
the gauge assembly.
30-P CONNECTORS
8. Lay a protective cloth on the combination switches
to prevent scratching the gauge assembly. Remove
the four screws, then take out the gauge assembly
as shown.
PROTECTIVE CLOTH
GAUGE
ASSEMBLY