nsxb23241a.pdf

Power Antenna Motor Test
1. Open the trunk lid and remove the side trim panel.
2. Disconnect the 4-P connector from the motor and
check power to the motor at the connector
terminals:
• There should be battery voltage between the
WHT/BLU (+) and BLK (-) terminals all the time.
• There should be battery voltage between the
PNK/WHT (+) and BLK (-) terminals only with
the ignition and radio switched ON.
WHT/BLU BLK
View from wire side
View from wire side
3. Test motor operation:
FULL EXTEND: Connect battery power to the No.
3 and No. 4 terminals and ground
to the No. 2 terminal.
RETRACT: Disconnect power from the No. 3
terminal.
4. If the motor fails to operate properly, replace it.
MAST
ANTENNA
MAST
ANTENNA
LEAD
POWER ANTENNA MOTOR
(With the antenna retracted fully)