nsxe23273a.pdf

Switch Removal
CAUTION:
All SRS electrical wiring harnesses are covered with
yellow outer insulation.
Before disconnecting the SRS wire harness, install
the short connector on the airbag (see page 23-323).
Replace the entire affected SRS harness assembly
if it has an open circuit or damaged wiring.
1. Remove the dashboard lower cover and disconnect
the 2-P connectors from the floor wire harness.
2-P
CONNECTORS LIGHTS-ON CHIME
FOOT LIGHT
DASHBOARD
LOWER COVER
2. Disconnect the 18-P connector from the floor wire
harness.
CAUTION: Be careful not to damage SRS wires.
REAR WINDOW
DEFOGGER SWITCH
18-P
CONNECTOR
3. Remove the tilt cover.
TILT COVER
4. Remove the steering column lower cover and upper
cover.
NOTE: Be careful not to damage the steering column
covers.
5. Remove the 4 screws, then remove the rear window
defogger switch and wiper/washer switch assembly.
REAR WINDOW
DEFOGGER
SWITCH
HAZARD
SWITCH
WINDSHIELD WIPER/WASHER
SWITCH