Shift Cable
Adjustment
1. Start the engine. Shift to reverse to see if the
reverse gear engages. If not, refer to Trouble-
shooting on pages 14-84 thru 14-87.
2. Stop the engine.
3. Raise the car (see section 1).
4. Shift the selector lever to position.
5. Remove the shift cable cover.
6. Remove the control lever pin and lock pin from the
control lever.
CONTROL LEVER PIN
CONTROL
LEVER
SHIFT CABLE COVER
6 x 1.0 mm
8 N.m (0.8 kg-m, 6 Ib-ft)
LOCK PIN
Install in this
direction.
7. Shift the control lever to position.
SHIFT CONTROL LEVER
12. Install the shift cable cover.
13. Start the engine and check the shift lever in all gears.
If any gear does not work properly, refer to
Troubleshooting on pages 14-84 thru 14-87.
If you feel the control lever pin binding as you rein-
stall it, the cable is still out of adjustment and must
be readjusted.
Install the lock pin as shown in step 6.
10. Tighten the locknut.
11. Install the control lever pin and lock pin.
NOTE:
LOCKNUT
LOCKNUT
NOTE: Left-hand
threads
ADJUST NUT
9. If not perfectly aligned, loosen the locknut on the shift
cable and adjust as required.
Cable Cable Exact
Too Short Too Long Alignment
SHIFT CABLE END
CONTROL LEVER
8. Check that the hole in the control lever is perfectly
aligned with the hole in the shift cable.
Adjustment
1. Start the engine. Shift to reverse to see if the
reverse gear engages. If not, refer to Trouble-
shooting on pages 14-84 thru 14-87.
2. Stop the engine.
3. Raise the car (see section 1).
4. Shift the selector lever to position.
5. Remove the shift cable cover.
6. Remove the control lever pin and lock pin from the
control lever.
CONTROL LEVER PIN
CONTROL
LEVER
SHIFT CABLE COVER
6 x 1.0 mm
8 N.m (0.8 kg-m, 6 Ib-ft)
LOCK PIN
Install in this
direction.
7. Shift the control lever to position.
SHIFT CONTROL LEVER
12. Install the shift cable cover.
13. Start the engine and check the shift lever in all gears.
If any gear does not work properly, refer to
Troubleshooting on pages 14-84 thru 14-87.
If you feel the control lever pin binding as you rein-
stall it, the cable is still out of adjustment and must
be readjusted.
Install the lock pin as shown in step 6.
10. Tighten the locknut.
11. Install the control lever pin and lock pin.
NOTE:
LOCKNUT
LOCKNUT
NOTE: Left-hand
threads
ADJUST NUT
9. If not perfectly aligned, loosen the locknut on the shift
cable and adjust as required.
Cable Cable Exact
Too Short Too Long Alignment
SHIFT CABLE END
CONTROL LEVER
8. Check that the hole in the control lever is perfectly
aligned with the hole in the shift cable.