nsxd14123a.pdf

SEALING RINGS
NEEDLE BEARING
SET RING
O-RINGS
Replace.
4TH CLUTCH
ASSEMBLY
THRUST WASHER
THRUST NEEDLE
BEARING
1ST GEAR
COLLAR
THRUST WASHER
1ST GEAR
NEEDLE BEARING
33 x 38 x 24 mm
THRUST NEEDLE
BEARING
THRUST WASHER
O-RINGS
Replace.
1ST CLUTCH
ASSEMBLY
CONICAL SPRING
WASHER
Replace.
LOCKNUT
Replace.
140 N.m
(14.0 kg-m, 101 Ib-ft)
SNAP RING
WASHER
THRUST NEEDLE
4TH/REVERSE
NEEDLE BEARINGS
34 x 40 x 20 mm
4TH GEAR
COLLAR
MAINSHAFT
Check splines for excessive
wear or damage.
Check bearing surface for
scoring, scratches or excessive
Mainshaft
Disassembly/Inspection/Reassembly
Lubricate all parts with ATF during reassembly.
Install thrust needle bearings with unrolled edge of bearing retainer facing washer.
Inspect thrust needle and needle bearings for galling and rough movement.
Before installing the O-rings, wrap the shaft splines with tape to prevent damage to the O-rings.
GEAR
BEARING
wear.
NOTE: