nsxb20065a.pdf

Trunk Lid
Replacement/Adjustment
1. Remove the mounting screws, then remove the rear hatch air scoop.
2. Disconnect the high-mount brake light harness connector, and remove the harness clamp from the support strut.
3. Remove the trunk lid by removing the trunk lid mounting bolts.
4. Installation is the reverse of the removal procedure.
NOTE:
• Make sure the high-mount brake light connector is connected properly.
• Adjust the trunk lid alignment.
TRUNK LID MOUNTING
BOLTS
6 x 1.0 mm
13 N-m (1.3 kg-m,
9 Ib-ft)
HINGE MOUNTING
BOLTS
6 x 1.0 mm
13 N-m (1.3 kg-m,
9 Ib-ft)
HIGH-MOUNT BRAKE
LIGHT HARNESS
MOUNTING SCREW
SUPPORT STRUT
SUPPORT STRUT
BOLT
TRUNK LID HINGE
Adjust the trunk lid hinges fore
and aft, and right and left as
needed to equalize the gap between
the trunk lid and the body.
REAR HATCH
AIR SCOOP
E-CLIP
Replace.
HARNESS
CLAMP
SUPPORT STRUT
SHIM
Use shims as required to make
the trunk lid fit flush with the
body at the rear edge.
HIGH-MOUNT
BRAKE LIGHT
HARNESS
STRIKER
Adjust the striker right or left to
align it with the trunk lid latch.
HIGH-MOUNT BRAKE
LIGHT HARNESS
TRUNK LID EDGE
CUSHIONS
Turn as needed to
make the trunk lid fit
flush with the body.
CORROSION RESISTANT BOLT
6 x 1.0 mm
10 N-m (1.0 kg-m,
7.2 Ib-ft)
TRUNK LID
TRUNK LID
HINGE