nsxb06031a.pdf

Locations
CAUTION: After installing the rocker shaft orifice, try to turn the rocker shaft to make sure that the orifice has been
inserted In the hole of the rocker shaft correctly- If the orifice is in place, it should not turn.
NOTE:
Identify parts as they are removed to ensure reinstallation in priginal locations.
Inspect rocker shafts and rocker arms (see pages 6-32 (’91-’93) or (’94-’96) and 33 (’91-’93) or (’94-’96) .
Rocker arms must be installed in the same position if reused.
Adjust the rocker arms after torquing the cylinder head bolts.
Prior to reinstalling, clean all the parts in solvent, dry them, and apply lubricant to any contact surfaces.
SEALING BOLTS 20 mm
60 N·m (6.0 kg-m, 43 Ib-ftl
EXHAUST ROCKER
SHAFT
WASHERS
Replace.
INTAKE ROCKER
SHAFT
Rear Cylinder Head:
SEALING BOLTS 20 mm
60 N·m (6.0 kg-m, 43 Ib-ft)
INTAKE ROCKER
SHAFT
WASHERS
Replace.
EXHAUST ROCKER
SHAFT
INTAKE ROCKER ARM ASSEMBLIES
RUBBER BAND
RUBBER BAND
CYLINDER NUMBER
CYLINDER NUMBER
RUBBER BAND
RUBBER BAND
EXHAUST ROCKER ARM ASSEMBLIES
EXHAUST ROCKER ARM ASSEMBLIES
Front Cylinder Head: