nsxb08003a.pdf

Engine Lubrication
Illustrated Index
FRONT CYLINDER
HEAD
ENGINE OIL PRESSURE GAUGE
SENDING UNIT
22 N-m (2.2 kg-m. 16 Ib-ft)
NOTE:
• Use new O-rings when reassembling.
• Apply oil to O-rings before installation.
• Use liquid gasket, Part No. 08718-0001.
• If the bottom of the oil pan is deformed, it should be
repaired or the oil pan should be replaced to retain
proper clearance between the screen and the
bottom.
OIL CONTROL ORIFICE
Remove with 6 mm
bolt and clean.
O-RING
Replace.
8 x 1.25 mm
22 N-m (2.2 kg-m
16 Ib-ft)
Replace.
ENGINE OIL
PRESSURE
SWITCH
OIL FILTER BASE
Illustrated Index,
page 8-12
OIL PUMP
Illustrated index, page 8-7
Inspection, page 8-8
Apply liquid gasket to
mating surface of engine block.
OIL PAN GASKET
Replace.
OIL PAN
• Do not deform
the bottom.
Refer to page 8-10
when installing.
OIL FILTER
One turn or
22 N-m (2.2 kg-m,
16 Ib-ft)
Replacement 8-5
6 x 1.0 mm
12 N-m
(1.2 kg-m, 9 Ib-ft)
6 x 1.0 mm
12 N-m
(1.2 kg-m, 9 Ib-ft)
DRAIN PLUG
20 x 1.5 mm
45 N-m (4.5 kg-m, 33 Ib-ft)
6 x 1.0 mm
14 N-m (1.4 kg-m, 10 Ib-ft)
ENGINE OIL
COOLER
WATER PASS PIPE
DOWEL PINS
SPECIAL BOLTS
8 x 1.25 mm
22 N-m (2.2 kg-m,
16 Ib-ft) O-RINGS
Replace. Replace.
OIL PASS
PIPE
SPECIAL BOLTS
6 x 1.0 mm
12 N-m
(1.2 kg-m, 9 Ib-ft)
Replace.
6 x 1.0 mm
12 N-m (1.2 kg-m, 9 Ib-ft)
DOWEL PIN
O-RINGS
Replace.
8 x 1.25 mm
12 N-m (2.2 kg-m,
16 Ib-ft)
OIL
SCREEN
WASHER
Replace.