Assembly
2. Roll the glass up and down to see if it moves freely
without binding. Also make sure that there is no
clearance between the glass and upper weather-
strip when the glass is closed. Adjust the position
of the glass as necessary (see pages 20-14 to 18(’93-’96)
20-13 to 17(’91-’92)
3. Attach the wire harnesses correctly on the door.
Assemble the door in the reverse order of disassembly,
and also:
1. Grease all the sliding surfaces of the regulator
assembly and the glass guides where shown.
WIRE HARNESS
NOTE: Make sure the wire harnesses are not
pinched.
4. When reinstalling the plastic cover, apply adhesive
along the edge where necessary to maintain a con-
tinuous seal and prevent water leaks.
NOTE: Do not fill these openings with adhesive.
PLASTIC COVER
ADHESIVE
DOOR
PLASTIC COVER
REGULATOR
ASSEMBLY
REAR GLASS GUIDE
FRONT GLASS GUIDE
2. Roll the glass up and down to see if it moves freely
without binding. Also make sure that there is no
clearance between the glass and upper weather-
strip when the glass is closed. Adjust the position
of the glass as necessary (see pages 20-14 to 18(’93-’96)
20-13 to 17(’91-’92)
3. Attach the wire harnesses correctly on the door.
Assemble the door in the reverse order of disassembly,
and also:
1. Grease all the sliding surfaces of the regulator
assembly and the glass guides where shown.
WIRE HARNESS
NOTE: Make sure the wire harnesses are not
pinched.
4. When reinstalling the plastic cover, apply adhesive
along the edge where necessary to maintain a con-
tinuous seal and prevent water leaks.
NOTE: Do not fill these openings with adhesive.
PLASTIC COVER
ADHESIVE
DOOR
PLASTIC COVER
REGULATOR
ASSEMBLY
REAR GLASS GUIDE
FRONT GLASS GUIDE