nsxb23276a.pdf

Power Windows
Driver’s Motor Test
Motor Test:
1. Remove the door panel (see section 20).
2. Disconnect the 4-P connector from the driver’s
motor.
View from
wire side
3. Test the motor by connecting battery power to the
No. 4 terminal and ground to the No. 3 terminal.
Test the motor in each direction, by switching the
leads from the battery.
CAUTION: When the motor stops running, discon-
nect one lead immediately.
4. If the motor does not run, replace it.
Pulser Test:
Connect the test leads of an analog ohmmeter to the
No. 1 and No. 2 terminals and check for needle move-
ment while running the motor by connecting battery
power to the No. 4 and ground to the No. 3 terminal.
The analog ohmmeter needle should move back and
forth alternately.
PULSER
Passenger’s Motor Test
1. Remove the door panel (see section 20).
2. Disconnect the 2-P connector from the motor.
View from wire side
3. Test the motor by connecting battery power to the
No. 1 terminal and ground to the No. 2 terminal.
Test the motor in each direction, by switching the
leads.
CAUTION: When the motor stops running, discon-
nect one lead immediately.
4. If the motor does not run, replace it.