nsxb20019a.pdf

Position Adjustment
After installing the door, check for a flush fit with the
body, then check for equal gap between the front, rear,
and bottom door edges and the body.
The door and body edges should also be parallel. Adjust
at the door hinges as shown.
CAUTION: Place a shop towel or rubber pad on the
jack to prevent damage to the door when the hinge
bolts are loosened for adjustment.
Lower the glass.
SHOP TOWEL/
RUBBER PAD
HINGE MOUNTING BOLTS
8 x 1.25 mm
30 N-m (3.0 kg-m,22 Ib-ft)
Loosen the hinge mounting bolts,
and move the door BACKWARD
or FORWARD, UP or DOWN as
necessary to equalize the gaps.
DOOR HINGE
DOOR MOUNTING BOLTS
8 x 1.25 mm
30 N-m (3.0 kg-m,22 Ib-ft)
Loosen the door mounting bolts
slightly to move the door IN or
OUT until flush with the body.
If necessary, you can install a
shim behind one hinge to make
the door edges PARALLEL with
the body.
CORROSION RESISTANT BOLT
The door and body edges should be parallel.
NOTE: Check for water leaks.
Striker Adjustment
Make sure the door latches securely without slamming.
If it needs adjustment:
1. Draw a line around the striker for reference.
2. Loosen the mounting screws, and move the striker
IN or OUT to make the latch assembly fit tighter or
looser. Move the striker UP or DOWN to align it
with the latch assembly opening. Then lightly
tighten the mounting screws and recheck.
STRIKER
MOUNTING SCREWS
8 x 1.25 mm
22 N-m (2.2 kg-m,
16 Ib-ft)
NOTE:
• Hold the outside handle out, and push the door
against the body to be sure the striker allows a
flush fit.
• Do not tap the striker with a metal hammer to
adjust the position.
3. If the door latches properly, tighten the mounting
screws and recheck.
NOTE: Replace the striker if it is cracked.
CORROSION RESISTANT SCREW
DOOR
JACK