nsxb20067a.pdf

Opener Cables
Replacement
1. Remove the openers and latches, then disconnect the opener cables.
2. Remove the fuel lid latch.
3. Remove the opener cables by removing the clips as shown,
NOTE:
Before pulling out the opener cables, tie a string to the opener cable so you can pull it back in later.
Take care not to bend the opener cables,
4. Installation is the reverse of the removal procedure.
NOTE:
Make sure the opener cables are routed and connected properly,
If necessary, adjust the opener cables by changing the position of the cable housing.
If necessary, replace any damaged clips.
Standard cable housing
position.
REAR HATCH
OPENER CABLE
REAR HATCH
OPENER
Replacement, see page 20-68
FUEL LID OPENER
Replacement, see page 20-68 FUEL LID
OPENER CABLE
FUEL LID LATCH
Replacement, see page 20-68
Clip locations
*: B or E
B: coupe
E: NSX-T (open top)
TRUNK LID
OPENER CASLE
TRUNK LID OPENER
ACTUATOR
Replacement, see page 20-69
TRUNK LID LATCH
Replacement, see page 20-69
LOCK CYLINDER
Replacement, see page 20-69
REAR HATCH
LATCH
Replacement, see page 20-68