Under-dash Fuse Box
Removal/Installation
SRS components are located in this area. Review the SRS
component locations, precautions, and procedures in the
SRS section 24 before performing repairs or service.
Removal:
1. Disconnect both the negative cable and positive
cable from the battery.
2. Carefully remove the side sill pad (pull it up, rear
end first).
3. Remove the fuse box door.
FUSE BOX
DOOR
SIDE SILL PAD
SIDE SILL TRIM
4. Remove the three screws, then remove the side sill
trim.
5. Remove the under-dash fuse box mounting bolts.
6. Disconnect the under-dash fuse box connectors.
NOTE: The SRS main harness connector is double
locked. To remove it, first lift the connector lid,
then press the connector tab down and pull the
connector out.
TAB
SRS MAIN HARNESS
7. Take out the under-dash fuse box.
Removal/Installation
SRS components are located in this area. Review the SRS
component locations, precautions, and procedures in the
SRS section 24 before performing repairs or service.
Removal:
1. Disconnect both the negative cable and positive
cable from the battery.
2. Carefully remove the side sill pad (pull it up, rear
end first).
3. Remove the fuse box door.
FUSE BOX
DOOR
SIDE SILL PAD
SIDE SILL TRIM
4. Remove the three screws, then remove the side sill
trim.
5. Remove the under-dash fuse box mounting bolts.
6. Disconnect the under-dash fuse box connectors.
NOTE: The SRS main harness connector is double
locked. To remove it, first lift the connector lid,
then press the connector tab down and pull the
connector out.
TAB
SRS MAIN HARNESS
7. Take out the under-dash fuse box.
Installation:
1. Connect the connectors to the under-dash fuse
box.
NOTE: To reinstall the SRS main harness connec-
tor, push it into position until it clicks, then close
the connector lid.
2. Install the under-dash fuse box.
3. Install the side sill trim, fuse box door and door sill
pad.
FUSE BOX
DOOR
SIDE SILL PAD
SIDE SILL TRIM
4. Connect both the negative cable and positive cable
to the battery.
5. Confirm that all systems work properly.