nsxd14146a.pdf

Manual Valve Detent Spring Parking Brake Stopper
Replacement/Adjustment
NOTE: Select the appropriate manual valve detent
spring when below parts are replaced.
Manual Valve
Manual Valve Detent Spring
Manual Valve Lever of Control Shaft
1. Install the main valve body, including the oil pump
gears, onto the torque converter housing and tight-
en to 12 N.m (1.2 kg-m, 9 Ib-ft).
See page 14-147.
2. Install the control shaft.
3. Install the manual valve detent spring on the main
valve body and tighten to 14 N.m (1.4 kg-m, 10
Ib-ft).
4. Set the manual valve to N position.
5. Measure the distance between the main valve body
and manual valve as shown.
Inspection/Adjustment
1. Set the parking shift arm in the position.
2. Measure the distance between the face of the park-
ing pawl shaft and face of the parking shift arm roller
pin as shown.
PARKING PAWL SHAFT
DISTANCE
PARKING PAWL
ROLLER PIN
PARKING
SHIFT ARM
PARKING BRAKE STOPPER
MANUAL VALVEMAIN VALVE BODY
DISTANCE 3. If the measurement is out of tolerance, select and
install the appropriate parking brake stopper from
the table below.
PARKING BRAKE STOPPERMANUAL VALVE
DETENT SPRING
CONTROL
N positionMANUAL VALVE
LEVER
5. If the measurement is out of tolerance, select the
appropriate manual valve detent spring using table
below, then install it and recheck.
PARKING BRAKE STOPPER
MANUAL VALVE DETENT SPRING
4. After replacing the parking brake stopper, make
sure the distance is within torelance.
LENGTH
SHAFT